B. Initial operation
Linksys SPA2102 initial operation
1. When ordering the Linksys SPA2102 from your provider, the device is automatically registered to the telephone system. Therefore, please check whether or not the MAC address is already registered in your Admin Portal under Configure > Devices. If not, add a new device.
)
2. After adding the device, add a new phone extension for the Linksys ATA under Extensions. Select the MAC address for the Linksys ATA under Devices.
)
3. Connect the analogue end device to the Linksys ATA (RJ-11). Make sure to use the PHONE 1 port.
The SIP account is only configured for PHONE 1 port, so that NO additional end device can be connected to PHONE 2 port.
4. Connect the LAN cable (RJ-45) to the Linksys ATA. Make sure to use the INTERNET port.
Do NOT plug the LAN cable into the ETHERNET port!
5. Connect the 5V power supply to the Linksys ATA.
It can take a few minutes until the Linksys ATA is ready for use, given that the configuration must be downloaded first.
This can take up to 15 minutes.
The Linksys SPA2102 is ready for use once the status LEDs Power, INTERNET and PHONE 1 remain lit.The INTERNET LED may not stay lit but only flash sporadically.This depends on the data traffic for your Internet connection.
Please note that the SPA2102 only supports block dialling.That is, after entering the full telephone number and confirming the selector key, a connection is established. The telephone number is then transmitted in one block.
)