2.1. Overview

The various telephone system functions (e.g. queues, timing, groups, etc.) can be configured on the administration portal. For detailed configuration information, please refer to the administration portal manual.

You can also configure the initial settings for the Panasonic telephone using the softkey “Setting”  “Application”. The following functions are available after pressing “Application”:

Call settings

Call waiting indication: define whether this function should be activated.

(optional, depending on settings on the administration portal) Timeout: set the ringing time.

(optional, depending on settings on the administration portal) Intercom: the intercom function enables speaking directly to a linked extension through the system, without dial tone and ring tone.

Caller ID block: set your entire number to be shown to the party being called, the switchboard number to be displayed or all caller ID information to be blocked.

Call forwarding: activate the function Call forwarding

Parallel call: configure another telephone or your mobile phone to ring in addition to your telephone when a call comes in. You can then answer the call with one of the two telephones.

Call forwarding: profiles

Here you can select your preconfigured call forwarding profiles.

For details, please refer to the Ncontrol manual.

You can edit the default profile directly via your device.

For details, please click here.

 

Telephone settings

  • Automatic redialling
  • Suggests number (if necessary, remove function)
  • Ring tone
  • Define as primary device
  • Logoff

Queues


Queues can be enabled or disabled; for set-up see administration portal manual)

Log into an existing queue directly via the telephone.Simply use to select the desired queue and press [ENTER] to confirm. To log out of the queue, select the respective queue again and press [ENTER] to confirm.An “x” before a queue indicates you are already logged in.